Open folder
Select your project folder.
Open your project folder in Verilog Atlas. The agent reads the design and the log. It finds the error. It writes a fix. You review the change. You run the test again and check the PASS/FAIL line. It helps you prepare for tricky systemverilog interview questions.
Select your project folder.
Read the simulation log.
Apply the suggested diff.
Check the exit code.
.3 filestb_counter.sv14 linessimulateexit 0PASS1 matchmodule tb_counter();
reg clk;
reg rst;
wire [3:0] q;
counter u0(clk,rst,q);
initial begin
clk=0; rst=1;
#10 rst=0;
repeat(4) @(posedge clk);
#1; $display(q==4?"PASS":"FAIL");
$finish;
end
always #5 clk=~clk;
endmoduleThis system verilog testbench example drives a clock, releases reset, waits for four edges, and checks the output value.
Verilog Atlas finds your design files and reads the log to see if the design failed, so it locates the exact line causing the error. You see the problem. The agent suggests a fix as a diff you accept or reject. Review every diff carefully before applying the change to the file. A passing simulation shows only that the tested cases behaved as expected. This does not prove the design is correct or meets timing. You can learn verilog in depth resources to understand how a system verilog testbench example behaves. Confirm the design works now by checking the exit code for success.
The agent runs your free verilog simulator command and waits for the simulation to finish before capturing the text output for review, so you can see the results immediately. It checks for X values. The agent verifies the waveform dump exists in the working folder. You review the diff of the log file carefully. You accept the results and save the log for later. The best way to start learning verilog involves running these commands yourself. You verify the test passed and check the timing details. The system runs locally without sending data to external servers.